Details

Bosch 800 Series SHE7PT55UC Dishwasher

• 24 inch Exterior Width
• 42 dB Decibel Level
• Full Console
• Stainless Steel (Interior)
• 6 Wash Cycles
• 16 Capacity (Place Settings)
• Stainless Steel colour

Pictures

Model  SHE7PT55UC

Parts

Problem

Won't Start

Turns on but display turns off when hitting start.

Fix

Could it be the door latch? Try pushing in the door.

E15 Water Leak

Possible causes for the E15 error code:

• A detergent that is not recommended for your dishwasher
• Too much detergent
• Clogged or damaged spray arms that are directing water in the wrong direction
• A leak in the sump basin (the area where the filter is located)
• Hoses that are leaking
• A leaking water tank

I found that the regeneration valve was leaking. When trying to remove it, it basically disintegrated. 

Part# 00630255 VALVE-REGENERATION

Replaced the valve with a new one and it worked!

Needed to lube the o-rings to get it to seat properly. Push in and rotate clockwise such that the latches grab.

E24 Blocked Drain

When your Bosch dishwasher displays error code e24, it means that the dishwasher is not draining properly due to the drain filter being blocked. Along with the E24 error code, you are likely to encounter several indicative symptoms signaling a drainage problem in your Bosch dishwasher. You may observe water pooling at the bottom of the dishwasher post-cycle, experience an interruption during operation with the dishwasher pausing or stopping unexpectedly, or hear unusual noises such as gurgling or humming. These all point towards a clog due to the drain filter being blocked.

Possible causes for the E24 error code:

• The drain hose could be blocked
• The dishwasher filter may need to be cleaned
• Brand new garbage disposal. The installer may have forgotten to remove the ‘knockout’ plug

Fix

https://www.youtube.com/watch?v=tHy05OiTcyI

E25 - Pump Blocked

The pump is blocked with foreign objects or the pump cover is not attached correctly.

Cleaning pump:
1. Set the programme selector to OFF. Pull out the mains plug. Attention: The pump may be blocked with glass fragments. There is risk of cutting yourself.
2. Remove the filters.
3. Remove the pump cover.
4. Remove all foreign objects.
5. Check whether pump impeller can be rotated freely.
6. Re-insert the pump cover including locking or screwing tight.
7. Also re-adjust the filters correctly and attach them if required.

Service Instructions

References