Enable TCP Forwarding over SSH
> setcfg LOGIN "SSH AllowTcpForwarding" TRUE
Reboot or go into UI and update the SSH Service
Update Cron
> vi /etc/config/crontab
> crontab /etc/config/crontab && /etc/init.d/crond.sh restart
Running Applications at startup (?? Don't think this works)
> /etc/init.d/init_disk.sh mount_flash_config
> vi /tmp/nasconfig_tmp/autorun.s
> /etc/init.d/init_disk.sh umount_flash_config
Verify that your changes are saved by verifying in the UI
UPS using Nut
UPS using APCUPSD
Local
Plug UPS into USB port.
From the QNAP UI, navigate to Control Panel → External Devices
Configure as follows:
Configure Remote UPS using APCUPSD
Edit the configuration
$ sudo vi /etc/apcupsd/apcupsd.conf
Set the following values
UPSCABLE ether UPSTYPE net #DEVICE <masterIP>:<port> DEVICE 192.168.1.50:3551 # If during a power failure, the remaining battery percentage # (as reported by the UPS) is below or equal to BATTERYLEVEL, # apcupsd will initiate a system shutdown. BATTERYLEVEL 50 # If during a power failure, the remaining runtime in minutes # (as calculated internally by the UPS) is below or equal to MINUTES, # apcupsd, will initiate a system shutdown. MINUTES 10
Start apcupsd
$ apcupsd
Test local configuration
$ apcaccess status APC : 001,036,0917 DATE : 2021-08-23 16:05:50 -0400 HOSTNAME : nas0 VERSION : 3.14.10 (13 September 2011) debian UPSNAME : MehanUPS CABLE : Ethernet Link DRIVER : Back-UPS ES 750 UPSMODE : Stand Alone STARTTIME: 2021-08-23 16:01:50 -0400 MASTERUPD: 2021-08-23 16:05:50 -0400 MASTER : 192.168.1.50:3551 STATUS : ONLINE SLAVE LINEV : 121.0 Volts LOADPCT : 13.0 Percent Load Capacity BCHARGE : 100.0 Percent TIMELEFT : 13.6 Minutes MBATTCHG : 0 Percent MINTIMEL : 3 Minutes MAXTIME : 0 Seconds SENSE : Medium LOTRANS : 092.0 Volts HITRANS : 139.0 Volts BATTV : 13.6 Volts LASTXFER : Low line voltage NUMXFERS : 0 TONBATT : 0 seconds CUMONBATT: 0 seconds XOFFBATT : N/A SELFTEST : NO STATFLAG : 0x07000408 Status Flag SERIALNO : 5B1036T73179 BATTDATE : 2010-09-05 NOMINV : 120 Volts NOMBATTV : 12.0 Volts NOMPOWER : 450 Watts FIRMWARE : 841.I3 .D USB FW:I3 END APC : 2021-08-23 16:06:39 -0400
Set APCUPSD to start at bootup
Mount the flash
$ /etc/init.d/init_disk.sh mount_flash_config
Edit the autorun.sh script
$ vi /tmp/nasconfig_tmp/autorun.sh
Add apcupsd to run
/sbin/apcupsd
Unmount the flash
$ /etc/init.d/init_disk.sh umount_flash_config