...
> crontab /etc/config/crontab && /etc/init.d/crond.sh restart
Running Applications at startup (?? Don't think this works)
> /etc/init.d/init_disk.sh mount_flash_config
> vi /tmp/nasconfig_tmp/autorun.s
> /etc/init.d/init_disk.sh umount_flash_config
Verify that your changes are saved by verifying in the UI
UPS using Nut
UPS using APCUPSD
Local
Plug UPS into USB port.
From the QNAP UI, navigate to Control Panel → External Devices
Configure as follows:
Configure Remote UPS using APCUPSD
Edit the configuration
Code Block |
---|
$ sudo vi /etc/apcupsd/apcupsd.conf |
Set the following values
Code Block |
---|
UPSCABLE ether
UPSTYPE net
#DEVICE <masterIP>:<port>
DEVICE 192.168.1.50:3551
# If during a power failure, the remaining battery percentage
# (as reported by the UPS) is below or equal to BATTERYLEVEL,
# apcupsd will initiate a system shutdown.
BATTERYLEVEL 50
# If during a power failure, the remaining runtime in minutes
# (as calculated internally by the UPS) is below or equal to MINUTES,
# apcupsd, will initiate a system shutdown.
MINUTES 10 |
Start apcupsd
Code Block |
---|
$ apcupsd |
Test local configuration
Code Block |
---|
$ apcaccess status
APC : 001,036,0917
DATE : 2021-08-23 16:05:50 -0400
HOSTNAME : nas0
VERSION : 3.14.10 (13 September 2011) debian
UPSNAME : MehanUPS
CABLE : Ethernet Link
DRIVER : Back-UPS ES 750
UPSMODE : Stand Alone
STARTTIME: 2021-08-23 16:01:50 -0400
MASTERUPD: 2021-08-23 16:05:50 -0400
MASTER : 192.168.1.50:3551
STATUS : ONLINE SLAVE
LINEV : 121.0 Volts
LOADPCT : 13.0 Percent Load Capacity
BCHARGE : 100.0 Percent
TIMELEFT : 13.6 Minutes
MBATTCHG : 0 Percent
MINTIMEL : 3 Minutes
MAXTIME : 0 Seconds
SENSE : Medium
LOTRANS : 092.0 Volts
HITRANS : 139.0 Volts
BATTV : 13.6 Volts
LASTXFER : Low line voltage
NUMXFERS : 0
TONBATT : 0 seconds
CUMONBATT: 0 seconds
XOFFBATT : N/A
SELFTEST : NO
STATFLAG : 0x07000408 Status Flag
SERIALNO : 5B1036T73179
BATTDATE : 2010-09-05
NOMINV : 120 Volts
NOMBATTV : 12.0 Volts
NOMPOWER : 450 Watts
FIRMWARE : 841.I3 .D USB FW:I3
END APC : 2021-08-23 16:06:39 -0400 |
Set APCUPSD to start at bootup
Mount the flash
Code Block |
---|
$ /etc/init.d/init_disk.sh mount_flash_config |
Edit the autorun.sh script
Code Block |
---|
$ vi /tmp/nasconfig_tmp/autorun.sh |
Add apcupsd to run
Code Block |
---|
/sbin/apcupsd |
Unmount the flash
Code Block |
---|
$ /etc/init.d/init_disk.sh umount_flash_config |