Overview
Uses 15 amp relay. Awkward to open. Flat plastic back pops into plastic shell but is glued. Power prongs are also lightly glued to the flat plastic back.
Uses an edge mounted daughter board for the ESP8266EX. Flashing leads for 3.3V, GND, RX and TX can be soldered to the edge mounting. Used the test point landing for GPIO0 on the daughter board test points side.
LED will light when relay is engaged. Side button will toggle the relay state.
GPIOs
GPIO | Component |
---|---|
GPIO05 | Led1i |
GPIO12 | Relay1 |
GPIO14 | Button1 |
Pictures
Register the Wyze Device
Before you can perform an over the air upgrade of the Wyze device, you will need to register it with Wyze. Download the Wyze app from the App store and connect the wyze device.
Screen captures of the setup:
Make sure to hit Cancel and not Upgrade.
...
SetOption0 0; SetOption36 1
template
{"NAME":"WyzePlugWLPP1","GPIO":[0,0,0,0,0,56,0,0,21,0,17,0,0],"FLAG":0,"BASE":18}
References
Reference | URL | ||||
---|---|---|---|---|---|
Redit Post | https://www.reddit.com/r/wyzecam/comments/l54d8b/instructions_and_software_install_tasmota_on_wyze/ | ||||
Flasher | https://github.com/elahd/wyze_plug_flasher | ||||
Wyze WLPP1 Template | https://templates.blakadder.com/wyze_WLPP1.html | ||||
Teardown Video |
|