You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 12 Next »

Objective

I would like to clean up my rims to make them look nicer. I am planning on painting the rims white and adding some baby moon hubcaps like in the following photo.



Rims/HubCaps

SpecDetails PictureNotes
Rims13" 

5 bolt on 4-1/2 Inch


Hub Caps9 1/2" Baby Moons

https://www.vintagetrailersupply.com/9-1-2-dome-hubcap-vts-595/

Hubcap Dimensions:

  • Inner Flange Diameter = 9.23"
  • Overall Outer Diameter = 9.56"
  • For these hubcaps to fit, your wheels must have a nub diameter of approximately 9-3/8" to 9-1/2"
  • Overall Inside Height at Center = 2.75"



Painting Rims

https://www.youtube.com/watch?v=u-TNsO33eqQ

https://www.youtube.com/watch?v=fJLTJSjAqFk


Process

  • Remove tires from vehicle
  • Clean with soap and water
  • Use Isopropyl alcohol to remove any grease buildup
  • Sanding with sanding wheel and wire brushes
  • Blow off dirt
  • Clean withIsopropyl alcohol
  • Add cards (from a deck of playing cards) wound the edge of the rim
  • Tape off valve stem if not already removed.
  • Paint with self etching primer. Required when painting bare metal.
  • Paint with primer
  • Paint with acrylic paint
  • Paint with clear coat (required?)


Supplies

ItemPictureCostDescriptionURL
Vinyl Gloves

$10.49

Vinyl Gloves

canadiantire.ca
Sanding Wheel

$18.99

3M Paint & Rust Stripper


"Scotch-Brite web strips quicker, lasts longer and cuts faster than conventional sandpaper"

canadiantire.ca
Wire Brushes

$17.23

Wire Brushes

amazon.ca
Self Etching Primer

$27.99

Dominion Sure Seal Super Acid Etch Primer, 12.35-ozcanadiantire.ca
Primer

$26.99Dominion Sure Seal 3-in-1 Auto Body Primer, 454-gcanadiantire.ca
Paint

$20.99Dupli-Color DA1670 Gloss White OSHA White General Purpose Acrylic Enamel - 12 oz.

canadiantire.ca

amazon.ca

Clear Coat

$20.99Dupli-Color Clear Coat Matte Enamelcanadiantire.ca


My Process

Sanding Rims

Since my tires are going to be replaced, I removed the valve stem and any weights in order to sand the entire surface of the rim.

I sanded down the rims using a 3M Paint & Rust Stripper sanding wheel followed by various wire brushes. 


Priming

So, initially I tried a primer with filler. This did not work well. Should have used a self etching primer. So, I stripped the paint and started over



References

ReferenceURL
How to Paint the Wheels on your Car

https://www.youtube.com/watch?v=u-TNsO33eqQ

How To Paint Rims FAST and CHEAP! (Best Method)https://www.youtube.com/watch?v=fJLTJSjAqFk
  • No labels