Flashing Tasmota
- Flash replacement ESP8266 chip (ESP-12F) using Wishiot ESP8266 Burning Fixture Development Board and Tasmotizer
Desolder CB3S chip and swap
- Desolder CB3S chip and replace with ESP12F chip
- Add 10K resister between GPIO15 and GND
Configure Device
From Tasmota's Console, issue the following commands:
Module 54 Backlog SetOption97 1; TuyaMCU 11,1; TuyaMCU 21,2; SetOption20 1; SetOption54 1; DimmerRange 100,1000 Restart 1
For some reason, the DimmerRange needed to be set again.
DimmerRange 10,1000