...
Make | Bosch |
---|---|
Model | B22CT80SNS01 |
Refrigerator Capacity | 16.27 Cu. Ft. |
Freezer Capacity | 5.52 Cu. Ft. |
Total Capacity | 21.8 Cu. Ft. |
Width | 35 5/8 Inch |
Depth | 30 1/8 Inch |
Height | 71 7/8 Inch |
No. of Shelves | 5 |
Gallon Door Storage | Yes |
Water Dispenser | Internal |
Ice Maker | Yes |
Other Features |
|
Pictures
...
Setup
Temperature Calibration
Compartment | Display Temp F/C | Actual Temp F/C |
---|---|---|
Fridge | 5 7 | 3 5 |
Based on above, the fridge temperature was NOT calibrated. Increased temperature reading by 3°F.
Service Test - 211 Fresh Food Temperature Adjustment
Press the Refrigerator Temperature UP +/ Keypad or Refrigerator DOWN -/ Keypad to change calibration of Fresh Food Temperature plus or minus 1°F increments up to 6°F.
Levelling the Doors
Having the doors just right is important since it will ensure that the doors close properly.
From the front to the back, there should be a 1/4 inch difference in levelness (higher in the front)... Adjust by the two adjuster foot pegs (front on floor).
Use a 1/4" socket and a ratchet to turn the adjuster foot pegs screws until the tops of the french doors are even with each other.
In order to get the doors to stay open and not close on their own, you need to ensure the fridge is level front to back and right to left.
To adjust the doors:
- Remove the grill
- Adjust the two adjuster foot pegs using a 1/4" bolt driver. Check for level.
- Ensure Doors at top of fridge are even with each other and door closed properly and door's hinge flap is operating correctly.
Problems
Door Closure
With the fridge level, the door flap can sometimes fail to catch. To address this, I added a spacer between the catch(bearing block) and the cabinet which brings the catch down slightly.
Freezer is Cold but Refrigerator is Warm
...
- Dirty Condenser Coils
- Malfunctioning Condenser Fan Motor
- Defective Evaporator Fan Motor
- Faulty Start Relay or Capacitor
- Evaporator Frosted Over
- Malfunctioning Temperature Control Board
Round 1
Observations
- Freezer is at temp(0F) but fridge is warm(57F).
...
- Is the fan working intermittently?
- Could there be a thermostat/control issue?
- Is it possible the door was not closing properly and the french door's door flap was not engaged?
Round 2
It Happened Again
- Checked condenser fan and it was working.
- Not the door flap
- Cycled the power and no change
- Turned off for 30-60 minutes and it started up and cooled!
- Could be:
- damper freezing closed due to bad fridge temp calibration
- defroster
- defrost timer
- damper stuck
- evaporator fan? (heard it, so unlikely unless the fan blades are messed up)
Current Thought
I think the temp was getting too cold in the fridge compartment causing the damper to freeze closed. Temperature displayed on fridge was 3F higher than actual. Setting the temp to 38F was equivalent to 35F(1.6C). Fridge was probably dipping below zero from time to time.
Fridge temperature was calibrated and set at 5C. We shall see if it happens again.
Few Days Later
Seems to be working fine at 5C. Graphing the temperature seems to show a fluctuation between 3.2 - 5C. Averaging at 3.8C.
The perfect temperature to keep your food fresher for longer, and avoid ice, is 37F or 2.8C.
Reducing temp to 3C.
Round 3
So, it stopped working again. Temperature too low?
- Tested Damper Motor - Failed to Open
- Tested Evaporator fan - Passed
- Tested Condenser fan - Passed
- Ran the damper motor again and it ran the second time.
Current Thoughts
I think the damper is freezing closed or the damper motor is flakey.
Increased temp to 5C.
After watching the YouTube video https://www.youtube.com/watch?v=0EZnLvuCN9o, I can say that our motor is noisy....
Should probably replace it.
I've ordered a replacement.
While waiting for the new damper motor assembly, I ended up removing the damper and cutting off about 5mm of the foam from the bottom of the door.
Worked fine until the replacement arrived (about 4 days with temp set at 5C)
Replaced part and set temperature down to 3C. Wait and see.....
Damper Repair
Remove cover by pushing up taps from the bottom and then slide cover down.
Unscrew mount and remove.
Disconnect power and unclip motor.
Damper:
Part# W10594329
Ice Maker Repair
The ice make arm was missing so I made a new one... Time will tell if it works.
...
Who really makes the ice maker?
Whirlpool W10683115
Observations
- part number on Bosch supplied ice maker is W10683115 (Whirlpool)
- Apparently W10683115
...
- was replaced with W10886931.
- W10886931 Parts Breakdown
...
I successfully replaced the arm with this part:
Wirlpool WP67004028 - Amazon ~$20
Parts
https://www.partselect.ca/Models/B22CT80SNS/?retfrus=1
...
# | Mfr Part# | Image | Description |
---|---|---|---|
818 | 00798550 | IceMaker Arm reliableparts.ca ~$93 (Way too expensive!) partselect.ca ~$106 Whirlpool ? W11559683 ~ $54 Wirlpool WP67004028 - Works! Amazon ~$20 | |
- | - | Could a arm from another brand work?? Ordered this one: WORKS!!! Wirlpool WP67004028 Ice Maker Shut-Off Arm Amazon ~$20 | |
825 | 00798555 | reliableparts.ca - $212 partselect.ca - $243 Whirlpool W10683115 |
Freezer
# | Mfr Part# | Image | Description |
---|---|---|---|
231 | 00798455 | Evaporator Motor Fan |
Fridge Assembly
# | Mfr Part# | Image | Description |
---|---|---|---|
314 | 00798467 | Control Unit (Damper Control Motor Assembly) reliableparts.ca ~$359 Whirlpool Part: WPW10594329 "Replaces AP6023299, W10207517, W10594329, 3281328, PS11756641" reliableparts.ca ~$180 I bought: amazon.ca ~ $88.98 ($53.99 + shipping $34.99) | |
303 | 12004484 | Whirlpool Filter 4 Part# UKF8001AXX-750 |
Compressor
# | Mfr Part# | Image | Description |
---|---|---|---|
508 | 00631840 | Whirlpool W11123104 Condenser Fan Motor Panasonic Fdqr107wd Bosch Part reliableparts.ca ~ $430 Whirlpool Part reliableparts.ca ~ $105 115V - 60Hz | |
533 | 00798480 | Defrost Heater | |
540 | 00713453 | Evaporator Coil |
Shelf/Rack Assembly
# | Mfr Part# | Image | Description |
---|---|---|---|
631 | 00798539 | Ice Scoop L: 22cm / ~9 in W: 9cm / ~ 3.5 in Replaced with: Berglander Stainless Steel Ice Scoop 6 OZ / amazon.ca |
Service Test
The service test functions are performed using the refrigerator display and keypad.
Enter Service Test Mode by performing the following sequence of events:
- Press and hold the Door Alarm Keypad.
- Press and hold the Refrigerator Temperature UP / +Keypad.
- Release the Door Alarm Keypad and wait 3 seconds.
- The Freezer display wil display SE confirming entry in the Service Mode.
- Press the Refrigerator Temperature UP +/ Keypad again to confirm entry in the Service Mode.
- Display wil show 101 in the left display and numeric or dashes in right display.
- Press Freezer Refrigerator Temperature UP / +Keypad and Freezer DOWN /-Keypad ot toggle through Service Test numbers.
- To exit service test mode, open and close refrigerator door or hold door alarm for 3 seconds.
See technicianServiceManual.pdf for service test details.
References
Reference | URL |
---|---|
User Manual | |
Technician Manual | How to: Properly remove the freezer door and bottom bins from Bosch French Door Refrigerator. |
Schematic | |
Wiring Diagram | |
Fix Damper - Fix your $150 Refrigerator Part! |