...
- Added a lot of glue and let it cure overnight before finishing assembly.
Notes:
- When adding the top tub mounts as depicted in the picture, they should seat up tightly against the tub. You may have to pull the tub up or tighten the screws a little bit each to bring the tup up.
- When attaching the agitator, I discovered that the top screw doesn't press hard enough against the shaft so I added a couple of washers above the compression rubber at the top of the bolt.
- Should have replaced the washer hub but didn't. It still can slip a bit.
LF (Long Fill) Error Code
...