...
- When attaching the agitator, I discovered that the top screw doesn't press hard enough against the shaft so I added a couple of washers above the compression rubber at the top of the bolt.
- . This would cause the agitator to make a big GRRRR sound when spinning down.
- Turns out the washer has become compressed.
- Thickness: 7mm
- Printed a washer using TPU with a thickness of 10mm and it still slips...
- Rubber washer dimensions should to be roughly:
- Thickness: 10mm
- OD: 20 mm
- ID: 10.5 mm
- Rubber washer dimensions should to be roughly:
- Added a stainless steel washer above the rubber washer to make a better fit.
- Could Should have replaced the washer hub but didn't. It still can slip a bit.
...
Repeat → Motor turns off.
Parts
https://www.reliableparts.ca/lookup/215461
References
Reference | URL |
---|---|
User Manual | |
Serice Manual | |
Parts | https://www.reliableparts.ca/lookup/215461/1463423 |
Drain Hose Installation | https://www.youtube.com/watch?v=BW-EwI5NLBM |
Installation Guide | |
*** Enter Diagnostic Mode | https://www.youtube.com/watch?v=v4vcQ8QNkXg&t=62s |
Whirlpool Washer Repair - How to Replace the Valve (Whirlpool # W10853723) | https://www.youtube.com/watch?v=bM2bXqE9H6s&t=396s |
Maytag Washer LF Low Flow Fault Diagnose & Repair | https://www.youtube.com/watch?v=N-iul4E3cTI&t=473s |
...