...

• When attaching the agitator, I discovered that the top screw doesn't press hard enough against the shaft so I added a couple of washers above the compression rubber at the top of the bolt.

Image Removed

• . This would cause the agitator to make a big GRRRR sound when spinning down.

Image Added

• Turns out the washer has become compressed.
  • Thickness: 7mm
• Printed a washer using TPU with a thickness of 10mm and it still slips... 
  • Rubber washer dimensions should to be roughly:
    • Thickness: 10mm
    • OD: 20 mm
    • ID: 10.5 mm
• Added a stainless steel washer above the rubber washer to make a better fit.

Image Added

• Could Should have replaced the washer hub but didn't. It still can slip a bit.

...

• Press the button again within 5 seconds to enter manual diagnostic mode.

• If done successfully, a single beep occurs and the three-digit display shows the User Interface ID# (H 80, H 8 1, etc.) for 3 seconds, then displays 000 and the Add A Garment indicator LED flashes.

Manual Tests

To check FRESH valve select and press the following:

WHITES START/PAUSE (turns on Fresh valve, cycle indicator flashes) WASH TEMP (selecting hot = hot valve; warm = hot & cold valves; cold = cold valve) START/PAUSE (turns off Fresh valve, cycle indicator is steady on).

To check DETERGENT valve select or press the following:

SUPER WASH or HEAVY DUTY START/PAUSE (turns on Detergent valve, cycle indicator flashes) WASH TEMP (selecting hot = hot valve; warm = hot & cold valves; cold = cold valve) START/ PAUSE (turns off Detergent valve, cycle indicator is steady on).

To check FABRIC SOFTENER valve select or press the following:

NORMAL START/PAUSE (turns on Fabric Softener valve, cycle indicator flashes) WASH TEMP (selecting hot = hot valve; warm = hot & cold valves; cold = cold valve) START/PAUSE (turns off Fabric Softener valve, cycle indicator is steady on).

To check BLEACH valve select or press the following:

DELICATE/HANDWASH START/PAUSE (turns on Bleach valve, cycle indicator flashes) WASH TEMP (selecting hot = hot valve; warm = hot & cold valves; cold = cold valve) START/PAUSE (turns off Bleach valve, cycle indicator is steady on).

To Lock the Lid press the following:

WATER SAVE/SPRAY RINSE or REMINDER RESET. Repeat to unlock.

To Test the Motor press the following: (Lid needs to be Locked)

Spin: To activate Spin, lid must be closed with lid lock

SPIN SPEED Motor/basket spins at 23 rpm.

Repeat → Motor/basket spins at 530 rpm.

Repeat →  Motor/basket spins at 1000 rpm.

Repeat →  Motor turns off.

Parts

https://www.reliableparts.ca/lookup/215461

Image AddedImage AddedImage AddedImage Added

References

...