...
- When attaching the agitator, I discovered that the top screw doesn't press hard enough against the shaft. This would cause the agitator to make a big GRRRR sound when spinning down.
- Turns out the washer has become compressed.
- Thickness: 7mm
- Printed a washer using TPU with a thickness of 10mm and it still slips...
- Added a couple of steel washers above the rubber washer to make a better fit.
- Rubber washer dimensions
- should to be roughly:
- Thickness: 10mm
- OD: 20 mm
- ID: 10.5 mm
- Added a stainless steel washer above the rubber washer to make a better fit.
- Could Should have replaced the washer hub but didn't. It still can slip a bit.
...