You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 18 Next »


Overview

Honeywell HE280C2010/U Higher Capacity Whole House Bypass Humidifier


Controller Images




Schematic


Here is the schematic that I put together based on some testing.

You would think that the GND pin on the 555 would go to ground via a pullup and that would be that.




Other thoughts:

  • D2 is a zener diode which acts as a voltage regulator for the 555 chip.


555 Timer Reference Diagram






The Fix


Since the solenoid was no longer activating, it seemed like a replacing it was in order. The replacement solenoid that I purchased was rated 24 VDC but didn't activate when connected. Perhaps the transistor Q1 does support the amount of current required by the new solenoid. 


I opted to bypass the 555 timer circuitry by connecting pin 4 of the internal connector (under cap) to ground. The 555 timer is not required. 




New Parts

PartCostImage
 Baomain 1/4 Inch Brass Electric Solenoid Valve for Air Water Valve N/C (Normally Closed) DC 24V$22.00 CAN

Generic Pneumatic Push in Quick Touch to Connect Fitting 1/4" OD Tube x 1/4" Male NPT 90 Deg Swivel Elbow Coupler.


I would have bought straight ones but couldn't find them for a good price.

$13.00 CAN for 5


Finish Product


Here is a picture of the finished fix. Should be more maintainable now that these changes have been made. The new solenoid valve will allow a lot of water to pass so I have ball valve (not shown) limiting the flow to a trickle.



Future Updates

  • Replace solenoid output connector with barbed connector

References

  • No labels